There are two main ways to clean exterior glass on a low-rise building. The traditional method is a scrubber and squeegee from the ground or a ladder, which leaves crisp edges and suits storefronts within reach. The other is a water-fed pole: a telescoping pole that feeds purified water through a brush, scrubbing the glass and rinsing it with water stripped of minerals so it dries without spotting. Poles keep the crew on the ground for second-story glass, cut down on ladder work and wash the frames in the same pass. Plenty of crews use both methods on the same building.
Height changes the whole job. Once a building goes beyond a few stories, the work moves to aerial lifts, boom equipment or rope access, and that is a specialist trade with its own fall protection requirements, training and insurance. A general cleaning crew should not be the one working off the roof edge. Interior glass is a separate task as well. Partitions, conference room walls, door glass and lobby panels collect fingerprints and smudges, and they need careful wiping so drips do not land on carpet, furniture or electronics underneath.
Not every mark on glass comes off with a squeegee. Hard water spots from sprinklers are mineral deposits bonded to the surface, and they need a dedicated mineral remover applied carefully so it does not haze or etch the pane. Construction residue, paint overspray, stucco and adhesive call for a different approach, often a blade in the hands of someone who knows which glass can take it, since tempered and coated glass scratch easily. A frequent mistake is cleaning the panes while leaving tracks and sills full of grit, which washes right back onto the glass with the next rinse.
Glass on a set route against St. George dust and storm splash
Glass in St. George picks up dirt from two directions. Red dust rides in on the wind for most of the year and coats storefronts, entry doors and the lower panes nearest the parking lot, so a window that was clear on Monday can look hazy by the weekend. The long dry stretches mean that film keeps building between visits rather than washing away. During July and August, short monsoon storms throw mud and splash against lower glass and frames, and the grit that settles in tracks and sills finds its way back onto clean panes. Routes here usually run the exterior more often than the interior.
Frequency tends to follow building type. Hurricane retail centers and other storefront-heavy properties send the most frequent requests, since customers judge the business through that glass. Single-tenant professional offices and multi-tenant buildings in Ivins and Washington usually settle on a monthly or quarterly exterior, with interior partitions done in between. In the hotter months, crews often start exterior work early, before dry heat and direct sun warm the glass enough to flash solution dry before the squeegee reaches it.
What changes a window cleaning quote
- Pane count and glass type
- Providers count panes or measure glass area. Small divided panes take longer than large storefront sheets, and coated, tinted or tempered glass may need gentler methods and more care with blades.
- Height and access
- Ground-level glass and water-fed pole work are the simplest to staff. Anything that needs a lift, boom or rope access adds equipment, specialist labor, fall protection and setup time.
- Inside, outside or both
- Exterior-only routes move quickly. Adding interior glass means working around desks, displays and occupied rooms, which slows the crew and usually means scheduling around business hours.
- Condition and buildup
- A first visit on neglected glass, mineral spots, paint or construction residue takes far longer than a maintenance pass. Once a building is on a regular route, each visit gets quicker.
A typical commercial window cleaning schedule
| Task | Cadence |
|---|---|
| Storefront and entry glass, exterior | Weekly or every other week |
| Entry door glass and push plates, interior | Each janitorial visit |
| Low-rise office exterior glass | Monthly to quarterly |
| Interior partitions and lobby glass | Monthly, spot cleaned in between |
| Frames, sills and tracks | With each exterior visit |
| Hard water and mineral spot treatment | Once or twice a year, as needed |
| Upper-floor glass by lift or rope access | Quarterly to twice a year |
This is the starting specification. After the walk-through, the provider adjusts the cadence to how your building actually operates.
What the scope normally covers
- Exterior glass by squeegee or water-fed pole
- Interior glass on doors and partitions
- Frames and mullions wiped down
- Sills and tracks vacuumed and wiped
- Screens removed, brushed and replaced
- Fingerprint and smudge spot cleaning
- Hard water spot removal on request
- Light construction residue removal where agreed
The final task list and cadence get specified between you and the provider when the quote gets written up.
Guides that go with commercial window cleaning
Commercial Window Cleaning by type of business
Where requests tend to come from
Businesses across the St. George metro send us commercial window cleaning requests, from St. George, Washington, Hurricane, Ivins, Santa Clara, La Verkin and the surrounding towns. See all areas.
Other cleaning services in St. George
- Commercial Cleaning in St. George
- Office Cleaning in St. George
- Janitorial Services in St. George
- Medical Office Cleaning in St. George
- Floor Care in St. George
- Post-Construction Cleaning in St. George
- Day Porter Services in St. George
- Commercial Carpet Cleaning in St. George
- Disinfection Services in St. George
